Service catalog

Full-system scan, road test, and inspection to isolate warning lights or drivability issues.

Track down shorts, parasitic drains, and sensor faults with factory-level tooling.

Chase clunks, squeaks, and vibrations to the originating component before parts are ordered.

Pressure-test the cooling system, verify thermostat and pump operation, and spot leaks early.

Battery, starter, fuel, and ignition checks to identify why the vehicle will not crank or fire.

Resolve inspection failures by pinpointing EVAP, O2 sensor, or catalyst issues.

OEM-spec oil and filter service with reset of maintenance reminders, a multi-point check, and pricing that includes up to 5 qts of oil.

Replace pads with proper bedding and brake system inspection for even wear.

Machine or replace rotors with new pads, torque to spec, and road-test for proper break-in.

Full fluid flush with moisture content test to restore pedal feel and corrosion protection.

Install and register a new battery, clean terminals, and verify charging system health.

Swap cabin filter media to improve HVAC performance and interior air quality.

Replace intake filter and inspect ducts for debris that can restrict airflow.

Exchange coolant with the correct specification and bleed the system of trapped air.

Full revival of long-stored vehicles including fluid refreshes, safety checks, and a prioritized repair plan.

Install the correct heat range plugs, gap to spec, and clear adaptive trims if needed.

Replace coil packs as a matched set and verify misfire counters reset to zero.

Reseal the top end to stop oil seepage and clean residual buildup around the cover.

Remove and reseal the housing to address common leaks on European platforms.

Replace pump, inspect belt drive, and refill with OEM coolant to keep temps in range.

Install a new thermostat assembly and confirm warm-up and operating temperatures are correct.

Swap front or rear dampers in matched pairs and torque all hardware under load.

Replace arm assemblies, bushings, and ball joints as needed, ready for alignment.

Install a new accessory belt and check tensioners and pulleys for smooth operation.

Fit a new radiator, transfer sensors, and pressure-test for leaks before refill.

Install a new alternator, inspect the belt drive, and verify the charging system is back within spec.

Replace the timing belt, tensioners, and related seals, set base timing, and road-test for proper operation.

Disassemble, inspect, and machine surfaces as needed before installing a new gasket and torqueing to spec.

Remove the oil pan, clean mating surfaces, reseal, and verify no leaks after refill.

Remove HVAC components as required to replace the heater core and bleed the cooling system.

Diagnose leaks, replace failed components, evacuate, and recharge the system to factory specifications.

Replace the affected steering components, flush the system, and prepare for post-repair alignment.

Plan and execute engine removal and replacement with rebuild options as needed, reseal, and calibrate for reliable operation.

Remove the transmission for replacement or full rebuild, update mounts and fluids, and verify shift quality.

Remove the transmission, replace the clutch, pressure plate, and release components, and adjust engagement.

Fabricate or replace brake lines end-to-end, bleed the hydraulic system, and perform leak checks.

Mobile inspection with scan tool, fluid checks, and a prioritized findings report before you buy.

Measure cylinder compression to assess engine health and document readings.

Safety inspection covering brakes, tires, fluids, and battery before a long drive.

Comprehensive yearly check to stay ahead of maintenance and state inspection issues.